silicone cartridge

silicone cartridgeSilikonkartusche Ottoseal S100

A so-called silicone cartridge is a rigid container with a movable bottom, which allows the silicone to squeeze out. The shape of the cartridge is very stable and you can not easily squeeze it by hand. In order to squeeze the silicone out of the cartridge, you therefore need a so-called caulking gun during processing (also called a cartridge press or a skeleton gun).

Cartridge meets cartridge gun

Insert the silicone cartridge into the gun from above and pressing the hand lever pushes a rod against the bottom of the cartridge from behind. As a result, the bottom moves into the interior of the cartridge, forcing the material in the cartridge out of the nozzle at the front. A restraint bar normally prevents the bar from slipping back and you also use it to release the empty cartridge.

Kartuschenpistole als SkelettpistoleSkeleton pistol with hand lever for pulling back the push rod and extrusion pistons for cartridges.

Storage of silicone cartridges

New or unopened silicone cartridges usually have a sell-by date between 9 and 24 months. It is recommended to store the silicone cartridges dry and between 5 and 20 degrees Celsius. This prevents premature drying or hardening of the silicone in the cartridge. If you do not buy the silicone cartridges for immediate use or due to a mass reduction, it is advisable to take a look at the remaining shelf life of the best before date.

If you have opened a silicone cartridge for use, you may not consume the standard 310 ml of contents completely. The content ranges, depending on the width of the joint, for about 7 m silicone joint. If material remains after the work, it is important to close the cartridge properly. This will prevent the silicone from drying out. The sealant dries very quickly in the air, so you should never put open opened cartridges aside.

Closure options for opened silicone cartridges

One way to seal an already opened silicone cartridge is with the help of a special cartridge closure. Here you will usually find two variants. A stopper, which you screw with a coarse thread into the opening of the cartridge or a cap, which you turn after turning the tip on the thread of the cartridge.

Kartuschen VerschlusskappeCartridges Cap for turning on the cartridge thread.

However, preserving the cartridge from drying out will work without a purchased cartridge cap. For example, you can turn a simple spack screw into the top of the cartridge. After screwing the remaining silicone dries, which is still in the top. This protects the cartridge from drying out for some time. If you re-use the cartridge, you only need to use a new tip.

Another possibility is the use of aluminum foil or cling film. Place a small piece over the opening of the cartridge and screw the tip back onto the thread. The foil used should cover the thread of the cartridge when screwing on the tip. The aluminum foil is pulled tight and closes the opening airtight. Since this method causes the silicone to dry under the film after a certain time, you should repeat the process every 14 days, if possible. Then simply squeeze the dried silicone graft out of the cartridge.