Press hand guns
Using a cartridge gun
A cartridge gun, also known as a silicone syringe, silicone gun or cartridge gun, is used by almost every craftsman or DIY enthusiast during renovations or refurbishments. It enables the precise application of sealants, adhesives and other materials from cartridges. To ensure that it lasts a long time and is used correctly, we describe how to use a cartridge gun correctly and how to care for and maintain it.
Using a cartridge gun
1. Preparation
Prepare the work area: Make sure that the work area is clean and well lit. Lay out old newspapers or a protective sheet to prevent dirt.
Prepare the cartridge: Cut off the tip of the cartridge with a cartridge cutter or a sharp knife. Be careful not to make the opening too large so that the cartridge tip also holds well on the thread of the cartridge, otherwise it can come off if too much pressure is applied.
2. Inserting the cartridge
Insert the cartridge: Pull the pressure rod of the cartridge gun back completely. Insert the cartridge into the press holder and slowly push the pressure rod forward until it touches the bottom of the cartridge.
3. Application
Applying the material: Hold the cartridge press at an angle of about 45 degrees to the surface. Press the trigger evenly to press the material out of the cartridge. Move the press continuously along the joint or the area to be treated.
Smoothing the joint: Use a smoothing tool, joint filler and smoothing agent to smooth the applied compound and remove excess material.
4. After application
Removing the cartridge: Pull back the pressure rod and remove the cartridge from the press. If the cartridge is not completely used, close the cartridge with a cap to prevent it from drying out.