Shower caulking- That's how it works
Water or moisture always finds a way. This negative experience has already suffered many who have been abandoned by your shower seal. Therefore, it is particularly important in damp rooms, such as the bathroom is particularly important that not only the tiles and joints are professionally set, but also it is very important that the shower is properly sealed. Too big are the dangers, which can eventually even have harmful effects. If water enters the construction layer of the tiles and even regularly, it damages the building fabric and the mold will not be long in coming. Especially when showering the floor are installed, a proper seal is of particular importance.
In our step by step guide, we would like to show you how you can properly seal your shower and in the future do not have to make bad experiences with leaking water, which ultimately endangers you and the building fabric.
Preparations and required material to seal the shower
Before you start, you must first make some preparations that will make your subsequent work easier and ensure a good result:
- The respective substrate must be clean and dry
- All non-adherent elements must be removed
- Cracks and holes must be compensated with repair mortar
What you need:
- Sealant, also called liquid film
- Sealing membranes for larger surfaces
- Sealing tape for the corners
- Sealing corners for the shower floor sealing
- Sealing sleeves for pipes and fittings
- Trowel for applying the sealant
Good to know: Liquid foil is not well suited for old porous lime or gypsum plaster, because these plaster types are too porous to bond with the seal.
Let's start with the sealing of the shower
- Step 1: Apply the sealant (liquid foil or sealing slurry) to the substrate in the first step. Bear in mind that the sealant also serves as an adhesive for the sealing strips here. The sealing tape must be pressed from top to bottom. Pay attention to a crease-free and bubble-free installation and the sealing tape should project at least 5 cm at the lower end.
- Step 2: Now imagine the corners on the floor. Fill in these and at best use prefabricated inside or outside corners. Working with sealing tape can lead to mistakes and frustration at the corners.
- Step 3: When you are done with the corners, it goes to the floor edges and transitions. Note, however, that this step is omitted if the shower element already ex works has a fleece projection. If this step is not followed, seal the respective transitions to the adjacent floor with sealing tape.
- Step 4: Let's get to the pipe connections, which also need to be sealed. To do this, use the sealing collars. Apply sufficient sealant and pay attention here also to freedom from wrinkles in the sealing collars. Then fill with the sealant again.
- Step 5: You have already edited the corners, edges and pipe connections accordingly. Now you can do the large-scale sealing of the wet area. Continue to use either the sealant or waterproofing membranes, which are ideal for larger projects.
Final tips for sealing the shower
Always make sure that you have really worked any job, no matter how small. Also do not save with the sealant. It may not be too much, of course, but here is something more, rather than too little.
When the first coat is applied, wait about 2 hours. Then apply a second coat of sealant. Now let it rest for one day.
Now you can tiled! I wish you success!



