Product Information:
Sikafloor 2640 is a pigmented, two-component, fast-curing epoxy resin coating for broadcast, drive-over parking garage and underground garage floors, or as a roller coating for industrial floors.
Fast curing
Very low odor during application
High abrasion resistance
High mechanical resistance
Glossy surface
De-icing salt resistant
Can be filled with quartz sand
Low emissions
Low yellowing
Areas of application:
Can be used as a system primer, broadcast layer, and sealer with high mechanical strength on concrete or cementitious substrates.
Lightly textured roller coating for normal to medium-heavy industrial surfaces.
Application instructions:
The substrate must be sufficiently load-bearing (compressive strength at least 25 N/mm²). The surface must be clean, cured, dry, free of grease and oil, and free of loose and flaking particles. The tensile strength of rigid, trafficable surface protection systems (OS 8) must not be less than 2.0 N/mm² on average and 1.5 N/mm² in individual cases. Insufficiently stable layers and contaminants must be removed mechanically, e.g., by blasting or milling. Any defects, holes, or breakouts must be filled with Sika products. Remove excess sand from sanded surfaces and clean with an industrial vacuum cleaner.
Before mixing, stir component A mechanically. Carefully combine components A and B in the specified mixing ratio before use. To prevent splashing or even spillage, mix the components briefly at low speed using an infinitely variable electric mixer. Then increase the mixing speed to a maximum of 300 rpm for thorough mixing. If Sikafloor 2640 is to be pre-filled with quartz sand (e.g., with the OS 8 system), add the specified amount of quartz sand after approximately 2 minutes. Mixing time is at least 3 minutes and is only complete when a homogeneous mixture is achieved. Transfer the mixed material into a clean container (repot) and mix again briefly as described above. When mixing and repotting the products, appropriate protective clothing must be worn: e.g., tight-fitting safety goggles, protective gloves, a long-sleeved shirt, work trousers, a rubber apron, and protective shoes.
To ensure even wetting of the substrate, we recommend thoroughly working the material into the surface (a second coat may be necessary). The material can be applied with a brush, roller, or rubber squeegee. The preferred method is a rubber squeegee. Follow with a cross-coat roller.
Substrate temperature: minimum +5°C, maximum +30°C
Working time: +5°C 30 min, +20°C 20 min, +30°C 15 min
Consumption:
Consumption varies depending on the system, whether it is applied in 2 or 3 layers, and whether quartz sand is added. See the data sheet for more information.
Primer: approx. 0.5 kg/m² Sikafloor 2640
Wearing layer: approx. 1.2 kg/m² Sikafloor 2640
Sealing: approx. 0.7 kg/m² Sikafloor 2640
Delivery form:
30 kg tin buckets (A+B)
Colors:
RAL 7016, 7023, 7030, 7032, 7035, 7037, 7038, 7040, 7042, 7043, 7044
This product is a production item and cannot be exchanged!