Silicone transparent

Silicone transparentSilikon transparent als Glaskleber

Who wants to seal in his kitchen or bathroom transitions, joints or fittings from dirt and moisture, usually attacks the silicone. For this purpose, it is recommended to use transparent silicone. While using colored silicone to accentuate or create a nice contrast to the tile or work surface, transparent silicone almost does not affect the appearance of the surfaces. Transparent silicone fits in rather discreetly into the overall picture and does not bother so much. When building aquariums and terrariums, transparent silicone is also the first choice. Here, silicone is not only used as a sealant but also as an adhesive. Joints and splices are hardly or not at all visible through the use. This in turn gives you the opportunity to make glued-on backgrounds or rock walls that consist of several parts appear as one surface. The transparent silicone joints do not stand out in color.

lll➤ Our transparent silicone

Properties of transparent silicone

In addition to the already mentioned optical advantages and the many different applications, the properties of the transparent silicone, compared to the colored silicones, basically remain the same. The transparent silicone is also made on a rubber basis and thus seals reliably and permanently. It remains flexible and tear-resistant according to the corresponding DIN standards and is available in different resistance for temperatures up to 300 degrees Celsius. Commercially available transparent silicone usually has a temperature resistance up to 150 degrees Celsius. As with the colorless variants, many variants belong to the acetate system and are crosslinking with vinegar, but there are neutral cross-linking transparent silicones or even MS Polymer in transparent. This has the consequence that acetic acid is split off during curing, which also creates the typical smell in the room where working with silicone. The curing is almost without shrinkage. Transparent silicone can be processed on almost any surface. Whether metal, ceramic or plastic, the surface should only be free of loose parts, dirt or grease.

Processing of transparent siliconeTransparentes Silikon an Glasscheibe

If the surface on which you want to pull the joint is cleaned free of grease, you are ready to go. First cut open the cartridge and unscrew the enclosed cartridge tip. Insert the cartridge into the silicone syringe and cut the screwed-on plastic tip with a cartridge cutter, for example. The shape of the tip makes it possible to adjust the size of the opening to the joint width to be pulled. The more precisely you cut the point here, the less surplus silicone can be removed afterwards. Now apply the silicone evenly and smooth it with a joint puller. It is advisable to mask the surfaces above and below the joint with some masking tape. Thus, excess silicone can easily be removed by removing the masking tape. It is also advisable, before smoothing the joint, to apply special smoothing agent on the silicone, so that a simple and clean removal is possible.

Good to know: A mixture of detergent and water is often sold as a good alternative to a special smoothing agent. However, rinsing agent can attack certain types of silicone, so that the joint is ultimately no longer properly tight. Our recommendation therefore always lies in the use of smoothing agent instead of a detergent-water mixture.