OTTOFLEX Liquid Foil is a surface waterproofing solution applied beneath tiles, slabs, ceramic coverings, marble, and natural stone to protect against non-pressing water. It is suitable for a wide range of substrates such as gypsum, plasterboard, plaster, (aerated) concrete, masonry, stone, and screed.
- Polymer dispersion based on butadiene-styrene
- Effective moisture barrier
- Compatible with standard tile adhesives and solvent-free coatings
- Compatible with sealants
- Ready-to-use, easy application by rolling, brushing, or troweling
- Very short drying time of 2–3 hours
- High crack-bridging capacity
- Plasticizer-free, solvent-free
Standards and Testing
Tested according to abP A1 and ZDB guidelines I/II “Testing of waterproofing materials and systems” by the Official Materials Testing Institute for Stones and Earth, Clausthal-Zellerfeld, Germany.
Tested according to abP A1 and requirements of the ZDB guideline “Instructions for waterproofing in combination with coverings and coatings made of tiles and slabs for indoor and outdoor use” by the German Tile Trade Association.
Tested by Prüftechnik IFEP GmbH, Osnabrück, Germany.
Applications
- Surface waterproofing beneath tiles, slabs, ceramic coverings, marble, and natural stone against non-pressing water
- Suitable for substrates such as gypsum, plasterboard, plaster, (aerated) concrete, masonry, stone, and screed
Surface Preparation
Substrates must be level, clean, stable, dry, oil- and grease-free, and free of dust, dirt, and loose particles. Remove residues by brushing and vacuuming. Surfaces must not contain cavities, burrs, or continuous cracks. Unevenness must be corrected before or after application using suitable tile adhesive.
- Maximum residual moisture values:
- Cement screed: 2%
- Anhydrite screed: 0.5%
- Heated anhydrite screed: 0.3%
Absorbent and highly absorbent mineral substrates, plasterboard, and other gypsum-based substrates must be treated with OTTOFLEX Primer and allowed to dry for at least 2 hours. Drying time depends on air and substrate temperature, air movement, humidity, and substrate absorbency. At +20°C and 50% relative humidity, drying time is approx. 2 hours.
Gypsum plasters must be solid, dry, smoothed, and at least 10 mm thick in a single layer. Polyethylene, polypropylene, and bitumen membranes are unsuitable substrates. For non-absorbent substrates made of chemical building materials such as polyurethane, polyacrylates, epoxides, etc., please consult technical support.
Application Instructions
Stir OTTOFLEX Liquid Foil thoroughly before use and apply with a roller (short-pile lambskin or foam roller). Corners between walls and floors must first be sealed with OTTOFLEX Sealing Tape, embedded into the fresh liquid foil, and coated generously. Then apply OTTOFLEX Liquid Foil evenly on walls and floors. After a minimum drying time of 1 hour, apply a second coat. A third coat is possible but not required. Clean tools with water after use.
- Minimum consumption: approx. 1.1–1.3 kg/m² (=0.8 l/m²) for a dry layer thickness of at least 0.5 mm
- After approx. 2–3 hours, standard tile adhesives can be applied using the thin-bed method
OTTOFLEX Waterproofing System is not suitable for sealing balconies or terraces. Due to the variety of possible influences during processing and application, a trial application is always recommended. The exact expiration date is indicated on the container and must be observed.
Packaging