Ottoflex Elastic Seal Corner
Secure connection with Ottoflex liquid film / sealing slurry / sealing membrane / sealing and decoupling membrane
Pre-shaped for optimal processing
Extremely elastic and tear-resistant
Resistant to ageing
Areas of application inside corner:
Composite sealing in damp and wet rooms under ceramic coverings and natural stone
Elastic sealing corners for permanently waterproof sealing on inside corners under tiles, slabs and ceramic coverings
Application instructions:
The surface is prepared with Ottoflex primer and a single application of Ottoflex liquid film/Ottoflex sealing slurry. The respective Ottoflex corner is inserted into the still fresh Ottoflex liquid film / Ottoflex sealing slurry and pressed into the on-site corner. During the second coating, the entire Ottoflex corner is also coated. Glue the Ottoflex inner and outer corners to the entire surface of the Ottoflex sealing membrane / sealing and decoupling membrane with Ottoflex M 500 or M 595 and smooth the transitions with the material that comes out. Because of the large number of possible influences during processing and application, the processor must always carry out a trial processing and application.
Standards and tests:
Corresponds to the water impact classes W0-I, W1-I, W2-I and W3-I for crack class R1-I according to DIN 18534
Corresponds to water impact class W1-B for crack classes R0-B and R1-B for container locations S1-B and S2-B according to DIN 18535
Corresponds to moisture resistance classes A0 and B0 according to ZDB and abP A, B, C
Corresponds to stress classes W1, W2, W3, W4, W5 and W6 according to ÖNORM B 3407
French VOC emission class A+
EMICODE EC 1 Plus - very low emissions
Delivery form:
Outer corner, approx. 15cm length, approx. 6cm sealing width
Moisture stress classes in the area regulated by building regulations (high stress):
A 1 Non-pressing water indoors:
Wall and floor surfaces subjected to direct or indirect stress; Frequent or long-term exposure to industrial and cleaning water, e.g. in showers in private and public areas or around swimming pools
B Water constantly pressing from the inside indoors and outdoors:
Container surfaces exposed to pressurized water, e.g. in swimming pools
C Non-pressing water with simultaneous chemical contamination:
Wall and floor surfaces with limited chemical exposure, e.g. in laundries or commercial kitchens
Moisture exposure classes in areas not regulated by building regulations (moderate exposure):
A 0 Non-pressing water indoors:
Directly or indirectly used areas that are not frequently used by industrial or cleaning water, e.g. in private bathrooms or hotel bathrooms and their floor areas with drains
B 0 Non-pressing water outdoors:
Directly or indirectly used areas outside and not above used rooms, e.g. balconies or terraces